Atkinson Dynamics AD-27 Especificações descarregar pdf (Página 6)

AgencyListings

AD-28X-MV UL(UJPX),(UJPX7),(UXPL,Marine)-

For indoor or outdoor use in Class I, Groups

  A,B,CandD,Division2;ClassII,Groups

  FandG,Division2;ClassIIIhazardous

 locations;Type4Xenclosure.

T-Code at Maximum Ambient Temperature, °C

Hazardous Location 40° C 65° C

ClassI,Division2,GroupsA,B,C,D T6 T5

ClassII,Division2,GroupsF,G T6 T5

Class III T6 T5

EXPLOSION HAZARD – SUBSTITUTION OF COMPONENTS MAY IMPAIR

SUITABILITY FOR CLASS I, DIVISION 2.

B. Unpacking.

AfterunpackingtheModelAD-28X-MV,examineitfordamagethatmayhaveoccurredin

transit.Iftheequipmenthasbeendamaged,donotattempttoinstalloroperateit,leaclaim

immediatelywiththecarrierstatingtheextentofthedamage.Carefullycheckallenvelopes,

shipping labels and tags before removing or destroying them.

Beforeattemptingtoinstalltheintercom,besurethatallpartslistedintheKITCONTENTS

LISThavebeensupplied.

C. Kit Contents List.

Qty. Description Part Number

 1 WiringBlock 140A326-01

 4 Screws,PhillipsHead 7000478-10

 4 Lockwashers 7074A010

 1 Resistor,1K,1W 101216

D. Mounting.

The selection of the mounting location for the device, its controls and the rout‑

ing of the wiring is to be accomplished under the direction of the facilities and

the safety engineer.

The intercom is intended to be mounted on any relatively ﬂat and rigid surface by the two

mountingearsontheexteriorofthehousing.Figure5isadimensionaloutlinedrawingshow‑

ingthepropermountingconguration.Thetwomountingearshaveslotsfor3/8"(M10)bolts

spaced5-5/8"to5-7/8"(14.3cmto14.9cm)apart.Hardwareformountingtheintercomtothe

surface is left up to the installer.

This unit is heavy and should be mounted on a rigid surface capable of sup‑

porting the weight of the intercom.

-4-

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sem comentários

Atkinson Dynamics AD-27 Especificações Página 6